Camco P.9 Series Betriebsanleitung PDF herunterladen (Seite 20)

C. Overload Indicator (OL) – When the motor is loaded to the current limit setpoint (CL set-

point is established by the setting of jumper J1 and the CL trimpot) this lamp will glow

RED. If the OL indicator remains lighted during control operation, a fault condition may

exist. Possible causes for this condition are as follows:

1. Motor is overloaded - check motor amps with DC ammeter in series with armature.

2. Motor may be defective - check motor for shorts or grounds.

3. The CL may be set too low - check position of jumper J1 and CL trimpot.

Note: In some applications, especially those requiring the motor to cycle on

and off or from one speed to another, the OL indicator may blink indicating a

transient overload. This is a normal condition for the application.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Camco P.9 Series Betriebsanleitung Seite 20